Updated November 2026

If your Murray E500 lawn mower won’t start, the problem is usually one of a handful of simple things: stale fuel, a fouled spark plug, a wrong choke position, or a safety interlock that isn’t engaged. This guide walks you through checking each one in order, from the easiest fix to the more involved, so you can get the engine running and back to mowing.

Start With the Basics: Fuel, Oil and Controls

Before touching any tools, confirm the mower has what it needs to run. Many no-start calls end right here.

Shopping for one? See our guide: Brand New Murray Lawn Mower Won't Start? 6 Best Parts & Fixes (2026).

  1. Check the fuel tank. If it’s empty or the gas has been sitting for more than about 30 days, it has likely gone stale and lost its ability to ignite. Drain it and refill with fresh unleaded gasoline.
  2. Check the oil level on the dipstick. Most four-cycle engines will not start, or will shut down, if the oil is low. Fill to the full mark.
  3. Confirm the fuel shutoff valve (if equipped) is open and the fuel line is not kinked or cracked.
  4. Make sure the blade-engagement or operator-presence bar is pressed and the throttle is set correctly.

Set the Choke and Throttle Correctly

A cold engine needs a richer fuel mixture to start. A warm engine that has already run needs little or none. Flooding a hot engine is one of the most common reasons it refuses to fire.

  • Cold start: Move the choke to the full or closed position and the throttle to fast.
  • Warm restart: Leave the choke open or partly open and set the throttle to fast or idle.
  • Flooded engine: Open the choke fully, set the throttle to fast, and pull the starter cord several times to clear excess fuel. Then wait a minute before trying again.

Inspect and Replace the Spark Plug

If fuel and controls check out, the spark plug is the next suspect. Remove the spark plug boot, unscrew the plug with a spark plug socket, and look at the tip. A dry black coating suggests a rich mixture, oil fouling suggests worn rings or valve guides, and a white or glazed tip suggests overheating. Clean any light deposits with a wire brush, check the gap against the value in your owner’s manual, and reinstall. If the electrode is worn or the insulator is cracked, replace the plug with the one specified for your engine.

Check the Air Filter and Carburetor

A clogged air filter starves the engine of air and makes starting difficult. Remove the cover, inspect the element, and tap out loose debris. Replace it if it is oily, torn or heavily caked. If the mower sat through the off-season without treatment, varnish in the carburetor jets can block fuel flow. Cleaning the carburetor or replacing the fuel filter often solves a no-start that persists after a fresh plug and fuel.

  • A spark plug socket with a rubber insert helps you remove and reinstall the plug without dropping it into the cylinder. View on Amazon
  • A feeler gauge lets you set the plug gap to the manufacturer’s specification rather than guessing. View on Amazon
  • A fuel stabilizer added to gas before storage helps prevent the varnish that causes most spring no-starts. View on Amazon

Common mistakes

  • Repeatedly cranking a flooded engine without opening the choke, which only makes things worse.
  • Assuming the spark plug is good because it looks clean. Test it with a fresh one if you have one.
  • Using ethanol-heavy or old gas and expecting a fresh start.
  • Overlooking the safety bar or operator presence control, which can prevent cranking entirely.
  • Ignoring the owner’s manual for the correct plug type and gap.

FAQ

Why does my Murray E500 start and then die?

This usually points to a choke that is still engaged, a clogged air filter, or a carburetor that needs cleaning. Move the choke to open once the engine is running and check the filter first.

How often should I replace the spark plug?

Many owners replace it once a season or every 25 to 50 hours of operation, but always follow the interval in your owner’s manual.

When should I take the mower to a repair shop?

If the engine cranks strongly but still won’t fire after you have verified fuel, spark and air, or if you suspect internal damage, consult a qualified small-engine technician.

Conclusion

Most Murray E500 no-start problems come down to fuel, choke position, the spark plug or the air filter, and you can check all of them in an afternoon. Work through the steps in order and you will usually find the culprit quickly. For related troubleshooting on other models, see Murray Lawn Mower Won't Start: 8 Causes and Step-by-Step Fixes.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our lawn mowers guides, checking product details against manufacturer specifications and owner feedback.