Updated November 2026

A Craftsman 7.25 163cc lawn mower that won’t start usually comes down to fuel, spark, or air getting to the engine in the wrong amount or at the wrong time. Most of the time you can find the problem in under an hour with a socket wrench, a spark plug socket, and a few minutes of patience. This guide walks through the checks in the order that solves the most cases first.

Check the Fuel and Oil First

Stale gasoline is the most common reason a small engine refuses to fire, especially if the mower sat over the winter. Gasoline loses its combustibles within about 30 days, and ethanol-blended fuel can start breaking down even sooner. Drain the old fuel into an approved container and refill with fresh, unleaded gasoline rated 87 octane or higher.

Shopping for one? See our guide: Craftsman M220 Lawn Mower Won't Start: 7 Best Recoil Starter Replacements (2026).

Next, check the oil level on the dipstick. Many Craftsman engines have an oil-level safety feature that prevents starting when oil is low, so top off to the full mark if needed. Do not overfill, because excess oil can foul the plug and cause smoking.

Inspect the Spark Plug and Ignition

Remove the spark plug with a 5/8-inch spark plug socket and look at the tip. A dry, black, or oily electrode points to a rich condition or worn rings, while a white or blistered insulator suggests overheating. Clean any carbon with a wire brush, check the gap against the value in your owner’s manual, and replace the plug if it looks worn or cracked.

Reconnect the spark plug wire firmly. A loose boot is a surprisingly frequent culprit. If you have a spark tester, hold it against the cylinder head while pulling the starter cord; a bright blue spark means ignition is working.

Set the Choke and Throttle Correctly

A cold engine needs a richer mixture to start. Move the choke lever to the full choke position for a cold start, then move it to run once the engine fires. A warm engine usually needs the choke off or partially open. Flooding is the opposite problem: if you have pulled the cord many times and the engine smells strongly of gas, leave the choke off, set the throttle to fast, and pull the cord slowly four or five times to clear the cylinder.

Clean the Air Filter and Carburetor

A clogged air filter starves the engine of air and makes it run rich. Remove the cover, tap out loose debris, and wash a foam filter in warm soapy water, letting it dry fully before oiling it lightly. A paper filter should be replaced.

If fuel has sat in the carburetor, varnish can block the jets. Many owners report that a carburetor cleaner spray applied through the throat and a few passes of a fine wire through the jets restores starting. If you’re not comfortable disassembling the carburetor, a small engine repair shop can handle it.

Check the Recoil Starter and Blade Engagement

If the engine turns over but never catches, the problem is fuel or spark. If the cord pulls with no resistance, the starter pawls or recoil spring may be broken, so the crankshaft is not rotating enough to start the engine. Also confirm the blade control bar is not engaged in a way that loads the engine, and that the deck is clear of grass buildup.

Quick Checklist

  1. Drain old fuel and refill with fresh gasoline.
  2. Check and top off oil to the full mark.
  3. Remove, inspect, clean, and gap or replace the spark plug.
  4. Confirm the spark plug wire is secure.
  5. Set the choke correctly for cold or warm starts.
  6. Clean or replace the air filter.
  7. Clean the carburetor if fuel has sat for months.

Common Mistakes

  • Pulling the cord endlessly on a flooded engine. Stop after several pulls and let the gas clear.
  • Using old fuel and assuming the problem is elsewhere.
  • Replacing the spark plug without checking the gap.
  • Overfilling the oil, which can cause smoke and plug fouling.
  • Skipping the air filter because it looks clean on the outside.

A quality spark plug socket with a rubber insert makes plug removal much easier without cracking the insulator. View on Amazon

A carburetor cleaner aerosol with a extension straw helps you reach the jets without disassembling the carburetor. View on Amazon

A fuel stabilizer added before storage keeps gasoline fresh for the next season. View on Amazon

FAQ

Why does my Craftsman mower start and then die right away?

This usually points to a clogged carburetor or a dirty air filter, which leaves the engine unable to hold a steady idle. Cleaning both and checking the choke setting often solves it.

How often should I replace the spark plug?

Many owners replace the plug once a season or after about 100 hours of use. Replace it sooner if the electrode is worn or the engine starts hard.

Can I use ethanol-free gasoline in my mower?

Ethanol-free gasoline is a good choice for small engines because it holds up better in storage. If you can’t find it, add a fuel stabilizer and use fuel quickly.

Conclusion

Work through fuel, spark, choke, and air in that order, and most Craftsman 7.25 163cc lawn mower starting problems will show themselves. Keep the fuel fresh and the filter clean to prevent most repeats. If the engine still won’t run after these checks, a small engine technician can diagnose internal issues safely.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our lawn mowers guides, checking product details against manufacturer specifications and owner feedback.